Laser Projector Setup
Article Interface of the «EasyCeiling LaserHelper» Server. Day-to-day operator work: How to work with the laser projector. Setup and calibration instructions are below.
1. Room preparation
Workshop requirements summary: Laser projector installation requirements.
1.1 Electrical and noise protection of the projector
1.2. Selecting where to install the projector (YouTube)
1.3. Projector mounting bracket (YouTube)
1.4. Marking the table for calibrating the projector (YouTube)
The video addresses the questions:
How to choose a backlighting zone taking into account dead zones
How to divide the backlight zone into sectors
The grid size must be a multiple of 2!
How to set control points
1.5. Computer and network preparation:
There must be a WI-FI router in the workshop to which the projector will be connected.
It is necessary to prepare a computer in the workshop from which the projector will be controlled.
The computer and the router should be connected to the unified local network of the company, EasyCeiling should be installed on the computer, connected to the MS SQL network database.
The computer must have Windows 10 or newer installed.
Organisation of the network (YouTube)
2. Software preparation
2.1. Pre-installation and configuration of the software (YouTube)
2.2. Projector card — table size, connection, scanner, sleep mode, display
2.3. WI-FI setting on the projector (YouTube)
3. Calibrating the projector
3.1. Calibrating the projector (YouTube)
Saving calibration:
Login: admin
Password: 123456789
Entered once per session, subsequent saves will not require login and password.
Hotkeys:
1 - selection of the first point
2 - selection of the second point
3 - selection of the third point
4 - selection of the fourth point
Arrows: shift the point by 1 conventional unit.
Arrows + CTRL: shift by 10 conditional units
Arrows + SHIFT: offset by 100 conditional units
Arrows + ALT: offset by 1000 conditional units.
WASD: move through the grid sections in the 3rd calibration step.
Spacebar: switch auto-rendering of changes on and off
Enter: switch pause on/off
3.2. Daily calibration of the projector (YouTube)
4. Configuring the projector software
4.1. Pulling the projection of the ceilings to the posts (YouTube)
4.2. Automatic change of projection frequency for more detailed display of large perimeters (YouTube)
Changing the frequency (“flicker”) is enabled in the program automatically.
4.3. Projector temperature compensation (YouTube)
5. Projector Software Interface
Article Interface of «EasyCeiling LaserHelper» Server program.
Login to advanced mode (for specialists only!), password to enable work with files:
Login: admin
Password: 12345
Projector malfunctions
If there is a problem with the projector, please send us information about it. Please refer to this article to find out exactly what you need to send for diagnosis.