Configuring the Honeywell 1470g Scanner
To work with EasyCeilingLaser in COM-port mode.
This manual is suitable for Honeywell Voyager XP 1472g, Honeywell Voyager 1450g, Honeywell Voyager 1452g, Honeywell 1450gHR 2D, Honeywell 1250g scanners.
The barcodes below can also be found in your scanner's manual.
Connect the scanner with a USB cable to your PC. The hardware will be automatically detected by the system if you are using windows 10 or newer. If you have an older windows? Reinstall with a newer one or replace with a computer with a newer windows. The following commands should be entered about 5 seconds apart
Reset the current settings.
Reset to factory defaults.
Activate COM mode operation by code:
Add a carriage return suffix.
A serial device should appear on one of the COM ports - this is your scanner, specify its port in the laser program. If the required device does not appear, try the instructions from the beginning.
To work with EasyCeilingLaser in keyboard mode.
Connect the scanner using a USB cable to your PC. The hardware will be automatically detected by the system if you are using Windows 10 or newer. If you have an older Windows? Reinstall with a newer one or replace with a computer with a newer Windows. The following commands should be entered about 5 seconds apart
Reset the current settings.
Reset to factory defaults.
Add a carriage return suffix.
Try opening the "Notepad" program and scan the order number several times with the scanner. The order number should be inserted several times in the notepad, each time on a new line. If this doesn't happen, try configuring again.
What questions does this article answer?
How to configure the Honeywell 1470g scanner?
How to connect the scanner to the computer?
How to reset the current scanner settings?
How to set factory parameters?
How to activate COM mode on the scanner?
How to add a carriage return suffix on the scanner?
How to determine the scanner's COM port?
How to check the scanner's functionality?
How to enable the scanner in keyboard mode?