Tolerance

  1. Tolerance settings

    • Maximum tolerance (in %)

    • Tolerance type:

      • General — Sums up tolerance across all sides

      • Average — averaged tolerance value.

      • Maximum — indicates the maximum tolerance from the drawing sides.

    • Display tolerance message on print — enable warning on print forms

    • Prohibit actions when there are intersecting sides on drawing — block further operations if intersecting sides are detected.

  2. Automatic curvature calculation

    • Use automatic curve calculation algorithm — activate curve calculation based on given parameters. (recommended setting)

    • Maximum segment length (cm) — upper limit of length for one segment.

    • Maximum angle in degrees — maximum allowed angle between adjacent segments.

    • Minimum number of segments — quantity at which curvature check will be performed.

  3. Angle counting in drawing

    Options exclude "extra" corner points when analyzing contour:

    • Don't count additional points in additional form "Level transition"

    • Don't count additional points in additional form "Wall shift"

    • Don't count additional points on straight sections

    • Don't count additional points at the beginning and end of curved section

  4. Ceiling minus

    • Don't check final ceiling size