Internal cutouts, niches, and roundings
Prepared from materials of Euroformat.
Tie an internal cutout or a column to the walls. Otherwise the drawing does not show where the shape sits relative to the contour.
Column and harpoon split
Two ways to tie it:
Center to center. Measure offsets x and y to the center of the cutout and its sizes a and b. Run the separating harpoon cut from the wall to the middle of a cutout side.
Diagonals. Shoot diagonals from the room corners to the cutout corners. Run the harpoon cut from a room side to a cutout corner.

In the program, set the split with the Cut form.
Cutout without a split
Tie a circle, square, or oval that does not split the harpoon to two walls at a right angle. For a circle these are offsets L1 and L2 to the center and radius r.

Niche
A niche is a cutout for a hidden cornice. Record the offset from the corner L1, the depth a, and the length b.

Corner rounding
A rounded corner needs two radii: outer and inner. On the diagram r1 and r2 are those radii, a and b are the straight stretches between them, and L1, L2, and L3 tie the shape to the walls.

In the program, build the rounding with the Round a corner form.
Curved cutout
Divide a smooth inner contour into steps of 5–50 cm. The tighter the bend, the shorter the step. The numbers on the wave are that step length in centimeters.
Close the cutout with diagonals to the step points. If the curve is separate from the main fabric, measure the smaller contour on its own and subtract it from the main one: that is a minus ceiling.



In the program, use the Curved section and Minus ceiling forms.